The ‘old’ insect hotel requires that the insects fly. Flying is the only way to arrive and that probably limits the usage that we see. The newly created coco insect hotel is created in a similar way, but I will not put it on the wall, but instead simply place it among the plants on the dirt. This way the insect hotel can serve a much greater amount of insects.

First step was cutting a cocunut in half. This is getting easier every time now that I’m getting some experience. With the coco cut open you need to remove all the white inside. I use a dull knife to cut the white ‘meat’ in small strips which are easy to remove. After drying the empty coconut I sanded the edges and that was the coco part. All done. Now I get some reed, and cut this into small pieces of around 4 cm each. I used two types of reed, new fresh green reed, and older dried up light brown reed. The fresh green reed was easier to deform, so it made it easier to fit inside the coco. Before putting the reed inside the coco I sanded it a little to take away any imperfections. I mixed sizes so that different insect could find different sizes rooms in our hotel.

I put some paper inside the back of the coco, so the reed does no go in to the coco all the way to the back. The paper fills up the back part, and after filling up the front with the pieces of reed I could align the pieces a little by pushing the a bit deeper into the paper, or by pulling them out a bit.

Step one: With a couple of pieces of wood we made the basic frame
Step two: We pained the basic frame the same color as the wall, so it will not stick out so much
Step three: We collected a couple of sticks and some bamboo, which we cut in lots of pieces of 3 centimeters
Step four: All the pieces were glued inside the frame.
Step five: Leave to dry, and hang outside.

Now we only need to be patient. Maybe some insect will find the hotel and visit it for a while. We shall see.